Mark reset of single suppressed signals:
To reset the MARK function for single signals, press the button MARK for 3 seconds.
Mark reset of all suppressed signals:
To reset the MARK function switch your PIEPS DSP PRO/DSP SPORT into SEND-mode and then
back to SEARCH-mode. With the PIEPS DSP PRO you also have the possibility to reset MARK
with the following described SCAN-function. All information from previously suppressed signals
is now reset and you can start with MARK again.
Old device mode:
Older analog transceivers are transmitting a weak continuous signal additional to the digital
pulse signal that can have an impact on the digital signal separation. In such cases, you may
nd for a short time that more signals are indicated than actually exist – the display “number of
burials” starts ashing (display of “old device mode”). To suppress (MARK) these transmitters
keep a distance of more than 1 m.
signal with continuous carrier
signal without continuous carrier
IMPORTANT!
In the case of multiple burials, an overlapping of signals can occur and especially in small areas can have
an impact on the digital signal separation. Results are longer operating times or a limited MARK-function.
More information can be found on www.pieps.com.
MULTIPLE BURIALS
To Next Page
Loading...
