PIEPS DSP SPORT Manual Guide

The Intelligent Transmitter – Gives maximum support in SEND-mode
In SEND-mode there are functions working in the background of PIEPS DSP PRO/DSP SPORT
that help to be found faster and more efciently in case of an emergency.
Auto-Antenna-Switch
If the transmitting antenna is negatively inuenced through external devices (i.e. mobile phone),
the range of receiving beacons is directly inuenced (reduction could be 30 % or greater).
The PIEPS DSP PRO/DSP SPORT is always transmitting with the strongest antenna for the
maximum range to the receiving beacon!
iPROBE-Support
Beacons with iPROBE ONE Support* will be automatically deactivated when probing with the
electronic probe PIEPS iPROBE ONE. Signal overlap is eliminated and the next strongest signal
is automatically shown on the display of the receiving beacon. The PIEPS iPROBE ONE supports
maximal in the case of a multiple burial. See also chapter „Multiple Burials“.
The PIEPS iPROBE Support gives the best solution for multiple burial situations!
*Beacons with iPROBE ONE Support: PIEPS DSP PRO, PIEPS DSP SPORT, PIEPS DSP (with
Software version 5.0 or greater), PIEPS DSP TOUR, PIEPS FREERIDE
More information can be found on www.pieps.com.
SEND-MODE
Press the main switch lock and push the main switch to the
“SEND“ position. The display indicates the SEND-symbol,
the remaining battery capacity, and the transmitting antenna.
Additionally an LED indicator light ashes simultaneous with the
transmitter bit timing.
When you are on a tour, make sure the “SEND“-mode is selected
throughout. The PIEPS DSP PRO/DSP SPORT will transmit a
continuously dened signal (457kHz) that can be picked up from
all other avalanche beacons (according EN300718).
| 06/14
26

PIEPS DSP SPORT Specifications

General

Frequency	457 kHz
Temperature Range	-20°C to +45°C
Marking function	Yes
Number of antennas	3
Multiple Burial Function	Yes
Range	50 m
Battery Life	200 h
Batteries	3 AAA