Pilatus PC-9 - Page 5

25mm
25mm
AILERON
Side View
30mm
FLAP
TP Screw (2.3x12mm)
Wooden Block
TP Screw (3x20mm)
Collar (5mm)
Wooden supporter
Install the wheel to the fixed landing gear.
4
Wooden Block(25x15x13mm)
2
5
Collar (5mm)
Wheel (90mm)
Wooden supporter
(41.5x28x26mm)
Landing gear(5mm)
2
1
8
TP Screw (3x20mm )
Landing gear straps
2
Gear door
2
1
Landing gear
(5mm)
1
Wheel (75mm)
Wooden supporter
(46x28x14mm)
1
4
TP Screw (3x20mm )
6
TP Screw (2.3x12mm)
1
Aluminum part(60x6mm)
Collar (5mm)
Collar (5mm)
Collar (5mm)
Collar 5mm
3
FLAP
AILERON
Steel wire (0.5x1500mm)
Steel wire (0.5x1500mm)
Epoxy the fixed landing gear to the main wing.
Install the wheel to the fixed landing gear.
Epoxy the fixed landing gear to the fuselage.
Adjustment of the aileron and flap to make sure
they can work perfectly.
72
14
74
73
70
71
Accessory list for the coming installation steps.
Epoxy main wings to the centre wing by main wing
joiners.
A A"
A = A"
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
B=B'
A=A'
A`
A
B`
B
The sketch when the wings assemble finished.
2
Steel wire (1.7x210mm)
2
2
2
2
2
2
Clevis
Rod (2x300mm)
Retainer
Screw (3x35mm)
Washer(3x15mm)
2
Washer(3x15mm)
Lock Nut (3mm )
10
Pin hinge(36x20x1mm)
2
Wood dowel (6x50mm)
Reinforcement Plate
1
2
2
Blind Nut (6mm)
Screw (6x50mm)
172
o
Connect the two flaps with metal wire,keep some space
between them and epoxy the pinned hinges to the flaps
as below.
2mm
Keep some space
between the flaps.
2
Steel
wire (1.7x210mm)
Steel wire (1.7x210mm)
10
Pin hinge(24x24mm)
Flap
1mm
Make sure they are in
the right position while
installing.
Trailing
edge
Keep some space about 1mm width between
trailing edge and flap.
Epoxy the flaps to the wings as illustration.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3
15
13
11
12
14
Accessory list for the coming installation steps.