Pilz PNOZ m ES EtherNet/IP - LED Status Indicators

Function description
Operating Manual PNOZ m ES EtherNet/IP
1003387-EN-05
12
Virtual inputs
PNOZmulti Configurator
I0 … I7 I8 … I15 I16 … I23
...
I120…I127
EtherNet/IP Byte 0:
Bit 0 … 7
Byte 1:
Bit 0 … 7
Byte 2:
Bit 0 … 7
...
Byte 15:
Bit 0 … 7
Output range
The outputs are defined in the PNOZmulti Configurator. Each output that is used is given a
number there, e.g. O0, O5... .
The status of output O0 is stored in bit 0 of byte 0; the status of output O5 is stored in bit 5
of byte 0 etc.
Virtual inputs
PNOZmulti Configurator
O0 … O7 O8 … O15 O16 …
O23
...
O120…
O127
EtherNet/IP Byte 0:
Bit 0 … 7
Byte 1:
Bit 0 … 7
Byte 2:
Bit 0 … 7
...
Byte 15:
Bit 0 … 7
} Status of LEDs:
LED status 1 Output Byte
The LED status of the base unit can be requested directly as follows
– Bit 0 = 1: LED OFAULT is lit or flashes
– Bit 1 = 1: LED IFAULT is lit or flashes
– Bit 2 = 1: LED FAULT is lit or flashes
– Bit 3 = 1: LED DIAG is lit or flashes
– Bit 4 = 1: LED RUN FS is lit
– Bit 5: Reserved
– Bit 6 = 1: LED RUN ST is lit (not for PNOZ m B0)
– Bit 7: Reserved
} Data exchange is displayed in Bit 5.
} Polling the payload data: 2 Bytes with the table number and segment number are sent
by the Master for access to the payload data table (15 Bytes are returned to the Mas-
ter).
Detailed information on data exchange is available in the document "Communication Inter-
faces PNOZmulti 2" in the section entitled "Fieldbus modules".