Need help?Do you have a question about the Pilz PNOZ m1p ETH and is the answer not in the manual?
General| Communication interface | Ethernet |
|---|---|
| Operating voltage | 24 V DC |
| Protection type | IP20 |
| Safety category | 4 |
| Standards | EN ISO 13849-1, EN IEC 62061, EN 61508 |
| Safety level | PL e |
Specifies intended application, system requirements, and safety assessment procedures.
Covers safety regulations, qualified personnel, and company responsibilities.
Details personnel qualifications, warranty, disposal, and critical safety requirements.
Explains built-in safety mechanisms and the system's operational functions.
Provides instructions for installing the control system within a control cabinet, including mounting and environmental considerations.
Explains how to connect expansion modules and fieldbus modules to the base unit using jumpers.
Outlines general wiring principles, safety precautions for connection terminals, and output configurations.
Emphasizes checking safety device operation after chip card exchange or project download.
Details procedures for loading projects from chip card or via integrated interface.
Details how to perform functional tests on relay outputs to ensure correct opening of safety contacts.
Provides SIL/PL category, PFH, and TM values for logic, input, and output units.
Lists safety data for cascading units and recommends using PAScal software for safety function calculations.
Emphasizes considering relay service life graphs for the validity of safety-related characteristic data.
Displays service life graphs indicating cycles before wear failure at different currents and voltages.
To Next Page
