Filling
• Open the lid of the water heating bucket, ensure that the power cord is not attached
to the water heating bucket.
• turn on the cold water tap and fill the water heating bucket NEVER fill the water
BELOW the MINIMUM water level mark or
ABOVE the MAXIMUM water level mark.
✓
✓
• Close the lid making sure that it is correctly attached.
• Plug the cord into the connector on the water heating bucket
• Plug the cord into a 230V wall socket switch away from hot or heated surfaces.
• Switch ON the wall socket switch. The water will start heating up.
• When the water is boiling switch OFF the wall socket switch. This is not an automatic
switch OFF appliance DO NOT leave the water heating bucket un-attended when
boiling.
• To avoid steam burns, face the steam hole away from you. Steam is dangerous.
To Next Page
Loading...