EasyManua.ls Logo

Pinnacle Remington REM-45-KFA-B - User Manual

Pinnacle Remington REM-45-KFA-B
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MODEL NUMBERS:
REM-45-KFA-B / REM-80T-KFA-B / REM-140T-KFA-B / REM-175T-KFA-B / REM-215T-KFA-B
CONSUMER: READ AND SAVE THESE INSTRUCTIONS
GENERAL HAZARD WARNING: READ AND UNDERSTAND
ALL OF THE INSTRUCTIONS IN THIS MANUAL BEFORE
ASSEMBLING, STARTING, OR SERVICING THE HEATER. Be
sure to comply with the instructions and warnings provided with this heater. Failure to
comply can result in re or explosion that can cause property loss, bodily injury, or loss
of life. Only persons who can follow and understand these instructions should operate or
service this heater. If you need heater info; such as an operating manual, labels, etcetera,
contact Pinnacle Climate Technologies at 800-641-6996.
DANGER
NOT FOR USE IN RESIDENTIAL LIVING AREAS OR IN
ENCLOSED SPACES WITHOUT ADEQUATE VENTILATION.
FOR OUTDOOR USE. INDOOR USE PERMITTED ONLY
FOR: THE TEMPORARY HEATING OF ADEQUATELY VENTILATED BUILDINGS OR
STRUCTURES UNDER CONSTRUCTION, ALTERATION OR REPAIR. This is an unvented
portable heater that uses air (Oxygen) from within the area in which it is used. Failure
to provide adequate combustion and ventilation air will result in asphyxiation, carbon
monoxide poisoning, bodily injury or death. Refer to “Ventilation” on Page 6.
FACTORY ID: 001
DANGER
Sauk Rapids, MN 56379 USA • Toll Free (800) 641-6996
Fax: 320-251-2922 • Web: www.remingtonheater.com • Email: info@pinnacleclimate.com
© 2019 Pinnacle Climate Technologies, Inc.
RBKM-403
User’s Manual &
Operating Instructions
KEROSENE FORCED AIR HEATER
Locating Your Serial Number:
Your serial number can be found on a white label on the right side cover of your heater. For Example:
150812779. Have your Serial Number ready before calling customer service at 800-641-6996.

Table of Contents

Questions and Answers

  • P
    pwillisAug 12, 2025
    Why does my Pinnacle Heater ignite but then shut off, showing 'E1'?
    • J
      Joseph PattersonAug 12, 2025
      Your Pinnacle Heater might be shutting off shortly after ignition and displaying 'E1' due to several reasons: * Incorrect pump pressure: Adjust the pump pressure. * Dirty filters: Clean or replace the air, lint, or fuel filter. * Dirty nozzle: Clean or replace the nozzle. * Dirty or malfunctioning photocell: Clean, replace, or adjust the photocell position. If the photocell is defective, replace it. * Wiring issues: Check the wiring connections between the main PCB and photocell. * Thermister sensor placement: For models other than 45-KFA, check the thermister placement. * Temperature limit switch: Replace the temperature limit switch.
  • T
    timothy38Aug 20, 2025
    What to do if my Pinnacle Heater won't operate and shows 'E1'?
    • A
      antonio75Aug 20, 2025
      If your Pinnacle Heater won't operate, the motor runs briefly, and the LED display shows 'E1', consider these potential causes: * Fuel tank: Ensure the fuel tank has fresh kerosene. * Pump pressure: Adjust the pump pressure. * Spark plug: Clean or replace the spark plug if it's corroded or has an incorrect gap. * Fuel filter or nozzle: Clean or replace the fuel filter or nozzle if they are dirty. * Fuel contamination: Rinse the fuel tank with clean kerosene if there's moisture in the fuel tank. * Electrical connections: Inspect the electrical connections between the transformer and circuit board. * Ignitor wire: Re-attach the ignitor wire to the spark plug if it's disconnected. Replace the ignitor if it is defective. * Rotor spacing: Adjust rotor.
  • F
    Fernando ThompsonAug 27, 2025
    What to do if my Pinnacle Heater does not turn on?
    • F
      foxreneeAug 27, 2025
      If your Pinnacle Heater doesn't turn on and the lamp isn't lit, here are a few things to check: * Overheated sensor: Push the power switch to the “OFF” position and allow the heater to cool for 10 minutes before restarting. * Power supply: Check the power cords for a proper connection and test the power supply. * Fuse: Check and replace the fuse if it's blown.
  • J
    Jennifer PerezSep 3, 2025
    Why is my Pinnacle Heater producing excess soot and has poor combustion?
    • S
      sreedSep 3, 2025
      Poor combustion and excess soot production in your Pinnacle Heater can be attributed to: * Dirty filters: Clean or replace the air or lint filter and the fuel filter. * Fuel quality: Flush the fuel tank and refuel the heater with good quality fuel. * Improper pressure: Ensure you are using the proper pressure. * Dirty nozzle: Clean or replace the nozzle.

Pinnacle Remington REM-45-KFA-B Specifications

General IconGeneral
BrandPinnacle
ModelREM-45-KFA-B
Heater TypeForced Air
Power SourceCorded Electric
Voltage120 V
Flame EffectNo
Adjustable ThermostatYes
Remote ControlNo
Overheat ProtectionYes
Safety FeaturesOverheat protection
BTU45, 000 BTU
Fuel TypeKerosene

Related product manuals