4
IMPORTANT SAFETY INSTRUCTIONS - WARNINGS
Warning: Read this entire document and follow all warnings and instructions before installing and using the EV Flex-AC Charger. Install and use this product only within the
specified operating parameters as instructed in the manual. Failure to comply can lead to property damage, injury, or death, and will void the Limited Warranty.
Warning: Do not use the EV Flex-AC Charger if any component appears to be broken, cracked, frayed, or show any indication of damage or defect.
Please contact the Pion Power Customer Service Department immediately, refer to page 12 for contact information.
Warning: The EV Flex-AC Charger is not user-serviceable, do not attempt to open, disassemble, repair, service, or modify the product.
Please contact the Pion Power Customer Service Department if assistance is needed, refer to page 12 for contact information.
Warning: Always plug the EV Flex-AC Charger directly into the outlet with the supplied power adapter. Do not use extension cords, multi-outlet adapter, multi-plug,
conversion plug or power strip to plug in the product.
Warning: Do not use private power generators as a power source for the EV Flex-AC Charger to charge vehicles.
Warning: Never disconnect the EV Flex-AC Charger’s power adapter from the power outlet while the vehicle is still charging. Always stop the charging process, disconnect
the charging handle from the vehicle, then disconnect the power adapter from the outlet.
Warning: Always inspect the outlet before plugging the EV Flex-AC Charger in and ensure all prongs of the power adapter are fully inserted into the outlet. The power
adapter may overheat and cause damage or injury if it is not inserted properly. Do not plug the product into an outlet that appears damaged, loose, or worn.
Warning: Always connect the EV Flex-AC Charger into a power outlet that is properly grounded.
Warning: Do not expose the EV Flex-AC Charger to any flammable, explosive, or combustible materials/vapors.
Warning: Do not install or use the EV Flex-AC Charger near flammable, explosive, or combustible materials/vapors, or if exposed to severe rain, snow, thunderstorm, or any
other inclement weather.
Warning: If possible, avoid installing the EV Flex-AC Charger in direct sunlight.
Warning: Handle all components of the EV Flex-AC Charger with care. Do not drop, drag, batter, twist, tangle, step on or exert strong force/impact on the EV Flex-AC
Charger.
Warning: Do not allow moisture, water, or debris to enter the openings of the EV Flex-AC Charger, especially the outlet, connecter or charging handle port.
Warning: Do not plug the EV Flex-AC Charger into an outlet if it is submerged in water or covered in snow. If the product is already plugged in, turn off the breaker before
unplugging the power adapter.
To Next Page
Loading...
Need help?
General