Pioneer AVIC-D1 - Default Chapter; Safety Information

AVIC-D1/UC
2
1234
1234
C
D
F
A
B
E
SAFETY INFORMATION
C
A
U
TI
O
N
This service manual is intended for
q
ualified service technicians; it is not meant for the casual do-it-
y
ourself
e
r.
Qualified technicians have the necessar
y
test e
q
ui
p
ment and tools, and have been trained to
p
ro
p
erl
y
and safel
y
re
p
ai
r
p
erformed
ca
n adversel
y
a
ff
ect
t
h
e
a
n
d
reliabilit
y
of
t
h
e
p
roduct
a
n
d
ma
y
v
o
i
d
t
h
e
.
If
y
ou
a
r
e
n
ot
q
ualified
to
t
h
e
re
p
air
of
t
hi
s
p
roduct
p
ro
p
erl
y
a
n
d
,
y
ou
s
h
ou
l
d
n
ot
ri
s
k
t
ryin
g
to
do
so
W
ARNING
W
ARNING
W
This
p
ro
d
uct
co
n
tai
n
s
lead
in
solde
r
a
n
d
cer
tai
n
elect
r
ical
p
arts
co
n
tai
n
che
m
icals
w
hich
a
r
e
k
n
o
wn
to
the
state
of
Health & Safet
y
Code Section 25249.6 - Pro
p
osition 6
5
This product contains mercury. Disposal of this material may be re
g
ulated due to environmental considerations.
For disposal or recyclin
g
information, please contact your local authorities or the Electronics Industries
Alliance: www.eiae.org.
DVD MECHANISM MODULE section precaution
1. EJECT LOCK MODE for DVD mechanism
In order to enter "EJECT LOCK" mode, reset start while pressing the "AV" and "INFO" keys together.
Pressing the "AV" and "INFO" keys until monitor backlight is turned on.
In order to exit "EJECT LOCK" mode, follow the same steps to enter this mode.
2. Before disassembling the unit, be sure to turn off the power. Unplugging and plugging the connectors
during power-on mode may damage the ICs inside the unit.
3. To protect the pickup unit from electrostatic discharge during servicing, take an appropriate treatment
(shorting-solder) by referring to "the DISASSEMBLY" .
4. After replacing the pickup unit, be sure to skew adjustment.
5. During disassembly, be sure to turn the power off since an internal IC might be destroyed when a connector
is plugged or unplugged.
CD MECHANISM MODULE section precaution
1. Before disassembling the unit, be sure to turn off the power. Unplugging and plugging the connectors
during power-on mode may damage the ICs inside the unit.
2. To protect the pickup unit from electrostatic discharge during servicing, take an appropriate treatment
(shorting-solder) by referring to "the DISASSEMBLY".
3. After replacing the pickup unit, be sure to check the grating.
- Service Precautions
1. You should conform to the regulations governing the product (safety, radio and noise, and other regulations),
and should keep the safety during servicing by following the safety instructions described in this manual.
is a trademark of DVD Format/Logo Licensing Corporation.