Need help?Do you have a question about the Pioneer DEQ-P6600 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.005% |
|---|---|
| Built-in Crossover | Yes |
| Time Alignment | Yes |
| DSP | Yes |
| Category | Digital Signal Processor |
| Channels | 6 |
| Inputs | RCA |
| Outputs | RCA |
| DIN Size | 1 DIN |
| Crossover | HPF/LPF |
Automatically adjusts time alignment and equalizer settings.
Selects MOVIE, MUSIC, MATRIX, or OFF modes for surround sound.
Sets speaker size (SMALL/LARGE) and type (FRONT, CENTER, REAR, SUBWOOFER, PHASE).
Outputs a test tone to each speaker for level balancing.
Adjusts speaker output levels while listening to the test tone.
Adjusts center frequency, level, and Q factor for FRONT, REAR, CENTER speakers.
Turns the auto-equalizer function on or off.
Explains warnings and cautions for auto TA and EQ, including potential damage and microphone placement.
Lists requirements like quiet environment, correct microphone, and amplifier settings.
Details how auto TA/EQ changes settings like fader/balance and equalizer curves.
Instructions for stopping the car, closing doors, turning off the engine, and setting the ignition.
Guides on fixing the microphone in the driver's seat headrest.
Covers seat selection, starting the unit, entering measurement mode, plugging in the microphone, and starting the process.
Explains completion message, error handling, cancellation, and microphone storage.
Lists common issues like power, no sound, and volume problems with causes and actions.
Addresses issues related to speaker adjustment, time alignment, subwoofer, and Dolby Pro Logic II.
Addresses microphone connection errors during auto TA and EQ.
Addresses speaker connection or amplifier input level errors.
Addresses issues with high surrounding noise during measurement.
Details power output, impedance, preout level, decoder, and subwoofer/speaker settings.
To Next Page
