To Next PageTo Next Page
Need help?Do you have a question about the Pioneer PL-300X and is the answer not in the manual?
General| Drive System/Method | Direct drive |
|---|---|
| Motor | DC servo motor |
| Speeds | 33 1/3 and 45 rpm |
| Signal to Noise Ratio | 78dB (DIN-B) |
| Effective Length | 221mm |
| Cartridge Type | Moving magnet (MM) |
| Frequency Response | 20 Hz to 20 kHz |
| Platter | Aluminum die-cast |
| Dimensions | 420mm (W) x 130mm (H) x 365mm (D) |
Selects platter rotation speed between 33-1/3 and 45 RPM.
Fine-tunes the platter rotation speed.
Returns tonearm to rest and cuts turntable power.
Controls the raising and lowering of the tonearm.
Initiates playback or stops it by returning the tonearm.
Allows the user to listen to the same record again.
Selects record size for automatic playback initiation.
Indicates platter speed accuracy via a strobe light.
Fine-tunes the platter rotation speed.
Selects platter rotation speed between 33-1/3 and 45 RPM.
Handles record tracking and controls turntable power.
Controls the raising and lowering of the tonearm.
Cancels harmful skating force during record play.
Supports and secures the tonearm when not in use.
Stabilizes records and absorbs vibration.
Protects the turntable from dust.
Initiates playback or stops it by returning the tonearm.
Allows the user to listen to the same record again.
Selects record size for automatic playback initiation.
Indicates platter speed accuracy via a strobe light.
Selects platter rotation speed between 33-1/3 and 45 RPM.
Handles record tracking and controls turntable power.
Controls the raising and lowering of the tonearm.
Cancels harmful skating force during record play.
Supports and secures the tonearm when not in use.
Stabilizes records and absorbs vibration.
Protects the turntable from dust.
Returns tonearm to rest and cuts turntable power.
Selects platter rotation speed between 33-1/3 and 45 RPM.
Controls the raising and lowering of the tonearm.
Steps for removing the turntable panel and base plate.
Procedure for removing the direct drive motor and tonearm.
Instructions for assembling the panel and base plate for PL-200/PL-300.
Instructions for assembling the panel and base plate for PL-255/PL-400.
Schematic overview of the PL-300 and PL-400 circuit.
Details the construction and principles of motor rotation.
Explains the function of the PD1003 IC in the oscillator stage.
Describes the PA2004 IC's role in comparator control.
Details the PA2005 IC's function in drive control.
Schematic overview of the PL-200 and PL-255 circuit.
Describes the operational sequence for starting play on PL-200.
Explains the lead-in, auto-return, and repeat operations of PL-400.
How to adjust the stylus drop point for automatic play.
Procedure for adjusting the tonearm auto-return point.
Adjusting DD motor waveforms for correct speed on PL-300/PL-400.
Adjusting DD motor for stationary stroboscope on PL-200/PL-255.
