To Next PageTo Next Page
Need help?Do you have a question about the Pioneer PL-400X and is the answer not in the manual?
General| Drive System | Belt Drive |
|---|---|
| Speeds | 33 1/3, 45 RPM |
| Overhang | 15 mm |
| Motor | DC Motor |
| Platter | Aluminum |
| Tonearm | Static Balanced |
| Output level | 2.5 mV (1 kHz, 5 cm/sec) |
| Frequency response | 20 - 20, 000 Hz |
| Wow and Flutter | 0.025% WRMS |
| Signal to Noise Ratio | 78dB |
Controls platter speed between 45 and 33-1/3 RPM.
Allows fine-tuning of platter speed.
Returns tonearm and cuts power to the turntable.
Lifts or lowers the tonearm for playback.
Starts playback, moves tonearm, or cuts power.
Repeats the current record play.
Selects record size for automatic play.
Illuminates stroboscope markings for speed checking.
Allows fine-tuning of platter speed.
Selects platter speed between 45 and 33-1/3 RPM.
Applies tracking force and controls power.
Lifts or lowers the tonearm for playback.
Cancels skating force during playback.
Supports and secures the tonearm when not in use.
Stabilizes records and absorbs vibration.
Protects records and turntable from dust.
Starts playback, moves tonearm, or cuts power.
Repeats the current record play.
Selects record size for automatic play.
Illuminates stroboscope markings for speed checking.
Selects platter speed between 45 and 33-1/3 RPM.
Applies tracking force and controls power.
Lifts or lowers the tonearm for playback.
Cancels skating force during playback.
Supports and secures the tonearm when not in use.
Stabilizes records and absorbs vibration.
Protects records and turntable from dust.
Returns tonearm and cuts power.
Selects platter speed between 45 and 33-1/3 RPM.
Lifts or lowers the tonearm for playback.
Steps for removing the unit's panel and base plate.
Procedures for assembling the panel and base plate for PL-200/PL-300 models.
Procedures for assembling the panel and base plate for PL-255/PL-400 models.
Schematic illustrating circuit interconnections for PL-300 and PL-400 models.
Details on motor construction, rotation, and speed detection.
Explanation of the PD1003 IC's oscillator function.
Explanation of the PA2004 IC's comparator control function.
Details on PA2005 IC drive control, pulse, and prevention circuits.
Schematic illustrating circuit interconnections for PL-200 and PL-255 models.
Explanation of the PL-200's operating mechanism, including start of play.
Explanation of the PL-400's lead-in and operating mechanism.
Details on how to perform repeated playback.
Steps to interrupt and resume record playback.
Procedures for manually starting and stopping playback.
Adjusting the stylus landing spot for automatic play.
Adjusting the auto-return mechanism's timing.
Adjusting the direct drive motor for specific models.
Adjusting the direct drive motor for specific models.
