Pioneer TX-220Z - User Manual

Operating Instructions
Bedienungsanleitung
_Mode d'emploi
“Istruzioni per uso
“This product is manufactured to comply with the radio inter-
ference requirements of EEC Directive 76/889/EEC and
62/499/ EEC.”
Thank you for buying this Pioneer product.
Please read these operating instructions thoroughly, so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
For the sake of convenience, these operating instructions are based
on the. model HE, and they can be used for the HB, YP, KU, KC, S
and $/G models. 7
The differences between the models are given below.
HE model: |
For Europe excluding U.K. (“HE’ stamped on packing case): Power
line voltage is AC 220 volts.
HB model:
For U.K. (‘HB’ stamped on packing case): Power line voltage is AC
240 volts.
YP model:
For Australia ("YP’ stamped on packing case): Power line voltage is
AC 240 volts.
KU and KC models: |
For U.S.A. and Canada (‘KU’ or ’KC’ eee on packing case):
Power line voltage is AC 120 volts.
S and S/G models:
For destinations excluding above (’S’ or ‘S/G’ stamped on packing
case): A 4-point (110 V/120 V/220 V/240 V) voltage selector switch is
provided.
NOTE:
Depending upon the model, the design of the power plug and the
power outlet differs.
The line voltage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cord into an outlet. If it is not set properly, change the setting ac-
cording to the LINE VOLTAGE SELECTION.
IMPORTANT NOTICE (For KU and KC models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.
WARNING: TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
STEREO DOUBLE CASSETTE
TAPE DECK AMPLIFIER
DC-110Z/DC-111Z
AO mass ga EP
FM/AM DIGITAL SYNTH ESIZER TUNER ae oe
TX-220Z/TX-221
TX-220ZL/TX-221ZL suze" 0
AM/FM STEREO TUNER
TX-110Z/TX-1112Z
TX-TITOZL/TX-1
1
TZ
Since
ee
STEREO TURNTABLE
PL-2202/PL-221Z
PL-1102Z/PL-111Z
LINE VOLTAGE SELECTION
(S and S/G models only)
Before your model is shipped from the factory, the switch is set to the
power requirements of the destination: nevertheless, you should
check that it is set properly before plugging the power cord into the
AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
Volts
120V =110V
240 V 220 V
Screwdriver
=
=<
4
a
E
HE (for Europe excluding U.K.), HB (for U.K.), YP (for Australia), —
KU (for U.S.A.) and KC (for Canada) models are not provided with
a LINE VOLTAGE SELECTOR switch.
WPIONEER’

Pioneer TX-220Z Specifications

General

Tuning Bands	FM, MW
Tuning Scale	Analog
Sensitivity (FM)	1.9 µV (IHF)
Signal to Noise Ratio (MW)	45 dB
Frequency Response (FM)	30 Hz to 15 kHz
Output (FM)	650mV
FM Tuning Range	87.5 to 108 MHz
Signal to Noise Ratio (FM)	70 dB
Distortion (FM)	0.3%
Dimensions	420 x 140 x 290 mm
Sensitivity (MW)	300uV