Need help?Do you have a question about the Pioneer TX-9800 and is the answer not in the manual?
General| Tuning Type | Digital |
|---|---|
| FM Frequency Range | 87.5 - 108 MHz |
| Signal-to-Noise Ratio (AM) | 50 dB |
| Capture Ratio (FM) | 1.5 dB |
| Output (MW) | 0.5 V |
| Type | Stereo Tuner |
| AM Frequency Range | 530 - 1605 kHz |
| Total Harmonic Distortion (AM) | 0.3% (MW) |
| Selectivity (AM) | 40 dB |
| Output Voltage | 1 V |
| Output (FM) | 1.0 V |
| Frequency Response (FM) | 30 - 15, 000 Hz |
Details on semiconductors, FM/AM sections, audio, and miscellaneous specs.
Lists furnished parts like antenna and operating instructions.
Explains front panel knobs, switches, meters, and indicators.
Visual overview of the tuner's functional blocks and signal flow.
Detailed block diagram of the Automatic Phase Control circuit.
Describes FM front-end, IF amplifiers, and AM tuner circuits.
Explains APC, muting, and indicator control circuits.
Instructions for disassembling the wooden case, bottom plate, and front panel.
Step-by-step instructions for stringing the dial cord.
Procedures for adjusting AM and FM tuner sections, including APC and tracking.
Identifies parts on front panel, top, and rear views.
Visual representation of unit assembly with labeled parts.
Additional specs for FM section and miscellaneous items for S/G types.
Compares part numbers for KU, S, and S/G types.
Shows schematic variations for S/G types compared to KU type.
Lists parts for the GWE-116 Tuner Assembly.
Details circuitry for LED assemblies 1 and 2.
Details Switch (AWX-113) and Power Supply (AWR-190) assemblies.
To Next Page
