22
<ARB7135>
RECORDING
7 Operating with the main unit
1. Select the source to be recorded using the Function buttons.
2. Start recording with TAPE 1 or TAPE 2.
3. Play back the source to be recorded.
¶ The TAPE 2 sounds cannot be recorded.
¶ The VCR/TAPE 1 sounds cannot be recorded with TAPE 1.
¶ The volume, tone, balance, and surround settings of this unit have no effect on
the recording signal.
7 Recording Monitor
When recording with TAPE 2, if the connected recording device has a recording
monitor function, turning ON the TAPE 2 MONITOR button will enable record-
ing to be carried out simultaneously with playback monitoring (the TAPE 2 indi-
cator lights).
TV CONTROL
PERSONAL
SURROUND
DSP MODEPRO LOGIC 5-D THEATER VIRTUAL
5.1CH TEST TONE CENTER
REAR.L REAR.R
MULTI
OPERATION
COMMANDER
SET UP
TV/VCR
DVD
LD/SAT
CD
VCR
TUNER
FUNCTION MODE CHECK
SYSTEM OFF
DISC
+1009
8
765
4
321
CHANNEL
MULTI CONTROL
D
Î
MULTI CONTROL COMMANDER
PRE-PROGRAMMED AND LEARNING
RECEIVER
TV
FQ
FQ
TV FUNC
VOL VOL
ENTER
MUTING
Select the source to
be recorded.
* Except for PHONO,
the sources can di-
rectly be selected
using MULTI CON-
TROL.
1.
1.
Turn ON the power of all equipment to be used.
Recording with TAPE 1 or TAPE 2
FUNCTION
1
1
1
BASIC OPERATIONS
2.
2.
Start recording with TAPE 1 or TAPE 2.
Play back the source to be recorded.
3.
3.
TUNER
PHONO VCR/TAPE1
DVD/TV*LD/SATCD
TAPE 2 MONITOR
To Next Page
Loading...
Need help?
General