CHEROKEE "E" SECTION
5. Engage the starter by rotating magneto switch clockwise
and pressing in.
6. When the engine fires, advance throttle to desired setting.
If the engine does not fire within five to ten seconds, disengage
starter and prime with one to three strokes of the priming pump.
Repeat the starting procedure.
Starting Engine When Hot:
1. Open the throttle approximately 1/2 inch.
2. Turn the master switch ON.
3. Turn the electric fuel pump ON.
4. Put mixture control in IDLE CUT-OFF.
5. Engage the starter by rotating magneto switch clockwise
and pressing in. When the engine fires, advance the mixture
control and move the throttle to desired setting.
Starting Engine When Flooded:
1. Open the throttle full.
2. Turn the master switch ON.
3. Turn the electric fuel pump OFF.
4. Put mixture control in IDLE CUT-OFF.
5. Engage the starter by rotating magneto switch clockwise
and pressing in. When the engine fires, advance the mixture
control and retard the throttle.
When the engine is firing evenly, advance the throttle to
800 RPM. If oil pressure is not indicated within thirty seconds,
stop the engine and determine the trouble. In cold weather it will
take a few seconds longer to get an oil pressure indication. If
the engine has failed to start, refer to the "Lycoming Operating
Handbook, Engine Troubles and Their Remedies."
Starter manufacturers recommend that cranking periods be
limited to thirty seconds with a two minute rest between cranking
periods. Longer cranking periods will shorten the life of the
starter.
691015 18
To Next Page
Loading...
