PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
07/15/06 XI - ELECTRONICS
3F9
k. Connect the battery connector to board terminals.
1. Ensure O-ring is fitted in plain end cap and correctly seated.
NO
TE: Red ELT’s have no O-ring; replace end cap using fresh RTV silicone rubber compound.
m. Refit end cap and secure with the screws previously removed.
NO
TE: Do not overtighten the end cap screws.
n. Place transmitter into its mounting bracket; replace rear mounting bracket by pushing plastic knob
into place.
o. Connect the pilot’s remote switch harness to the transmitter.
p. Connect the antenna coax to the transmitter.
q. Install the access plate on the right side of the fuselage aft of sta. 259.30. Make an entry in the
aircraft logbook, including the new battery run out date.
NO
TE: It may be advisable to test the unit operation before installing the access plate. (Refer to
paragraph 11-6.)
Figure 11-1. Two Year, Magnesium Battery Connections
To Next Page