Pipishell PILFK Series - Step 5: Attach Arm Assembly;Wall Plate to Wall; Wall Mounting Options; Step 5 A: Wood Stud Option

5
Step 5
For wood stud installation, follow STEP 5A
For concrete installation, follow STEP 5B
Attach the Arm Assembly/Wall Plate [01] to Wall
Step 5A Wood Stud Option
X
●Ensure the arm assembly/wall plate is securely fastened to the wall
before continuing on to the next step.
● Any material covering the wall must not exceed 5/8 in. (16 mm)
● Nominal wood stud size: common 2 x 4 in. (51 x 102 mm) minimum 1½ x 3½ in. (38
x 89 mm)
● Stud center must be verified.
WARNING:
●Avoid potential personal injury or property damage! DO NOT over-tighten the lag bolts
[A1]. Tighten the lag bolts [A1] only until the washers [A3] are pulled firmly against the
wall plate.
5A-1
06
Attach the Extensions [07] to the Wall Plate [01] if Needed
For 16’’ Studs, no need extensions[07]
Option A:
●DONOT USE ANCHOR [A2] FOR THIS STEP!