When the function indicator is turned off, you can check
the current mode by pressing “SET” slightly.
Fire the flashgun
1）Check if all connections are completed. See if all the
power is turned on and the flashgun's parameter is set.
2） Half press the camera shutter release, transmitter
then send out the signal and wake up the “ sleeping”
flashgun (Flash in Standby mode).
3） Fully press the camera shutter release, transmitter
then send out flash signal and trigger the flashgun to
sync flashing.
When using the transmitter which is not compatible to
camera models; you need to half press the shutter
button of transmitter once, the camera can sync
shooting within one minute. You'll need to half press
the transmitter button again if time exceeds.
Some of the flash wake up time may take longer, we
suggest to half pressing the button for little bit longer
then fully press the button to shoot. Try to avoid fully
press the buton till the end.
To Next Page
Loading...
