Pixel Voical Air - Charging; How to Set the AB Group of the Transmitter?; How to Set the Transmitter Channel?; How to Set the Receiver Group and Channel?

6 7
How to Use
time; the channels of transmitter A, transmitter B must be the
same as the channel of receiver.
2.How to set the AB group of the transmitter?
Press and hold the " " set button and "-" button at the same
time, release the buttons after the "A or B" flashes on the left
side of the screen, short press the power button to switch group
A or group B. After adjustment is completed, press the " " set
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
3.How to set the transmitter channel?
Press transmitter " " set button, When the “CH**” character
flashes, you can adjust the channel by pressing “+” and “-”
button. After adjustment is completed, press the " " set button
again to exit, or, It will automatically exit and save the channel
adjustment after 3 seconds.
4.How to set the receiver group and channel?
Press receiver " " set button once, when the “A-CH**”
character flashes, you can adjust the channel by pressing “+”
and “-” button. After adjustment is completed, press the " " set
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
Press receiver " " set button twice, when the “B-CH**”
character flashes, you can adjust the channel by pressing “+”
and “-” button. After adjustment is completed, press the " " set
button again to exit, or, it will automatically exit and save the
channel adjustment after 3 seconds.
For example: for A channel, the signal channel of the
transmitter is set as CH01 and the signal channel of the
receiver is set as CH01; the schematic diagram is as follows:
+
+
How to Use
5. You can directly adjust the transmitter DB sensitivity by
pressing the “+” and “-” buttons.
6. You can directly adjust the receiver monitor volume by
pressing the “+” and “-” buttons.
5. Charging
When the battery capacity is low, it shows red, during charging,
the lightning sign is shown and the charging grid runs slowly,
after the battery capacity is full, the charging grid stop running.
After using Type-C interface 5V 1A input, the microphone can
work continuously.