59Operating the system
3.6 Retrieving a run
Once a profile has completed, the data are stored within the controller's internal memory. The
controller will always store the last run. This run can either be retrieved by DeltaT or written to a
USB flash drive.
See:
Retrieving the last run using DeltaT
Writing the last run to a Usb flash drive.
3.6.1 Retrieving the last run using DeltaT
1. When the power-up cycle has completed, use the cursor keys to highlight the Run from PC
option.
2. Then press the Enter key.
3. The display will then change to the PC mode screen .
4. From DeltaT, use the Retrieve last run to recall the run data. Refer to the documentation
provided with DeltaT for more details.
3.6.2 Writing the last run to a USB flash drive
1. From the main menu, use the cursor keys to highlight the Run from PC option.
2. Then press the Enter key.
3. The last run will then be written to the USB flash drive as a PDF file.
The data file written from the menu option will be given the prefix PIDM followed by the run number.
The run number will be the same as that used when the run was originally executed.
Tip
When a pdf file is written automatically at the end of the run it is given the prefix PIDA. This
ensures that the data files written manually using the menu option will never overwrite an
automatically created file.
59
59
55
To Next Page