To Next PageTo Next Page
Need help?Do you have a question about the Planet Audio AC1000.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Max Power | 1000W |
| Bass Boost Frequency | 45Hz |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| RCA Inputs | Yes |
| Speaker Level Inputs | Yes |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 0.2V to 6V |
| Crossover Type | Variable |
| Bass Boost | 0dB / +6dB / +12dB |
Lists all items provided in the ANARCHY amplifier packaging.
Explains the amplifier's performance and requirements when operating at 2 Ohm loads.
Advice on safely preparing and executing installation procedures within a vehicle.
Steps and considerations for securely mounting the amplifier in the vehicle.
Diagram and instructions for connecting 2-channel amplifiers via low-level RCA inputs.
Diagram and instructions for connecting 4-channel amplifiers via low-level RCA inputs.
Diagram and instructions for connecting the 5-channel amplifier via low-level RCA inputs.
Diagram and instructions for connecting mono-block amplifiers via low-level RCA inputs.
Diagram and instructions for connecting 2-channel amplifiers via speaker-level inputs.
Diagram and instructions for connecting 4-channel amplifiers via speaker-level inputs.
Diagram and instructions for connecting the 5-channel amplifier via speaker-level inputs.
Diagram and instructions for connecting mono-block amplifiers via speaker-level inputs.
Wiring configurations for 2-channel stereo and bridged operation of amplifiers.
Instructions for setting up 2-channel amplifiers in Tri-Mode for speakers and subwoofer.
Wiring configurations for 4-channel stereo and bridged operation of amplifiers.
Instructions for setting up 4-channel amplifiers in Tri-Mode for speakers and subwoofer.
Wiring configurations for 5-channel stereo and bridged operation of amplifiers.
Instructions for setting up the 5-channel amplifier in Tri-Mode for speakers and subwoofer.
Diagram and instructions for wiring mono-block amplifiers in mono configuration.
