Planet GSD-1222VHP - Rack Mounting

To Next Page

To Previous Page

3.2 Rack Mounting

To install the 802.3at PoE+ Switch in a 19-inch standard rack, follow the

instructions described below.

Step 1: Place your 802.3at PoE+ Switch on a hard at surface, with the front

panel positioned towards your front side.

Step 2: Attach a rack-mount bracket to each side of the 802.3at PoE+ Switch

with supplied screws attached to the package. Figure 3-2 shows how to

attach brackets to one side of the 802.3at PoE+ Switch.

4 6 82

1 3 5 7

12 14 1610

9 11 13 15

20 22 2418

17 19 21 23

Menu (5 sec)

Enter

Back

SFP

PWR

Down

5 9 13 17 21

3 7 11 15 19 23

PoE

2 6 10 14 18 22

4 8 12 16 20 24

PoE

PoE In-Use

ACTLNK1000

ACTLNK10/100

ACT

LNK

SFP

25 26

GSW-2620VHP

Figure 3-2: Attaching the Brackets to the 802.3at PoE+ Switch.

You must use the screws supplied with the mounting brackets.

Damage caused to the parts by using incorrect screws would invali-

date the warranty.

Step 3: Secure the brackets tightly.

Step 4: Follow the same steps to attach the second bracket to the opposite side.

Step 5: After the brackets are attached to the 802.3at PoE+ Switch, use suitable

screws to securely attach the brackets to the rack, as shown in Figure

3-3.