Controller input configuration in PlanetCNC TNG software
Axis:
User selects machine axis from drop down menu. Selected axis will be height
compensated.
Dec Pin:
Dec input pin number, located at INPUT header of controller. Select input pin number from
drop down menu.
When this input pin is active, machine will move/compensate in negative direction.
Down signal from torch height controller is connected to this input.
Inc Pin:
Inc input pin number, located at INPUT header of controller. Select input pin number from
drop down menu.
When this input pin is active, machine will move/compensate in positive direction.
Up signal from torch height controller is connected to this input.
OK Pin:
OK input pin number, located at INPUT header of controller. Select input pin number from
drop down menu.
If set, software waits until this input is active and only then begins with program
execution.
Arc OK signal from torch height controller is connected to this input.
Range Min/Max:
Low and high limit compensation travel.
Speed:
Speed of compensation moves. Units are mm/s or inch/s.
13
To Next Page
Loading...