THC related g-codes
6 THC related g-codes
THC compensation can be enabled or disabled, as also additional gcode parameters can
be used so that machine behaviour will suit your plasma cutting requirements for better
cutting results.
M54 - Enable/Disable THC
Usage: M54 P <Q> <R> - P = zero for Off, otherwise On
- Q = speed limit
- R = constant speed
If speed limit is set then THC will not move Z axis if machine speed is below set speed.
If constant speed is enabled then THC will not move Z axis if machine is accelerating or
decelerating.
Example:
M54 P1 Q1000 R1 – enable THC for constant speeds (no acceleration) above 1000.
15
To Next Page
Loading...