Need help?Do you have a question about the Plasmatronics D2020N and is the answer not in the manual?
General| Brand | Plasmatronics |
|---|---|
| Model | D2020N |
| Category | Inverter |
| Language | English |
Connect the battery positive to Battery+ and negative to Battery-.
Connect the negative wire from the solar panel to the negative terminal.
Test solar panel connection by touching positive wire to the Test terminal (T).
Connect the DC load circuit to the load negative and positive terminals.
Advance to next menu item or setting value by pressing and releasing the button.
Select a sub-menu or change settings by holding the button down.
Return to top-level menus using short pushes, with exceptions noted.
Configure the current time using short and long button pushes.
Select the correct system voltage for your battery type.
Choose a pre-set program for your batteries or customize setup.
Enter battery capacity in Ampere hours (Ah) for accurate monitoring.
Summary of data points available in the data submenu for system monitoring.
Access performance information for the last 99 days of operation.
To Next Page