SHARPENING SCISSORS
Use the aluminium oxide blue/grey
grinding wheel. This module is suitable
for all straight edge, household scissors.
Do not use with serrated, wavy edged
blades or pinking shears
1. Slide module 1, labelled Knife &
Scissor Sharpener, onto the Power Unit.
2. Switch the Power Unit on.
3. Open the scissors fully.
4. Slide the first scissor blade through
the front guide slot (1d) - keep the pivot
of the scissors and other blade to right
hand side.
5. Draw the blade across the grind-
ing wheel from pivot to tip. Use a light
steady pressure, do not press too hard
(1e).
6.Remove and turn scissors over to
sharpen the second blade (1f) - keep
the pivot to the right and sharpen from
pivot to tip.
7. Repeat if necessary, until clean
sharp edges are achieved.
8. Switch Power Unit off. Before
removing the module, ensure that the
grinding wheel has stopped.
To Next Page
Loading...