Knife & Scissor
Sharpener
USE THE ALUMINIUM
OXIDE BLUE/GREY
GRINDING WHEEL
SHARPENING KNIVES
Use the aluminium oxide blue/grey
grinding wheel. This module is suitable
for all straight edge, household knives.
Do not use with serrated edged blades
1. Slide module 1, labelled Knife &
Scissor Sharpener, onto the Power Unit.
2. Switch the Power Unit on.
3. Hold the knife handle towards you
and insert the handle end of the blade
into guide slot (1a)
4. As soon as the blade touches the
grinding wheel, draw it with light
steady pressure across the wheel to
the tip - then remove. Do not press
hard (1b)
5. Insert the second side of the blade
into the other top guide slot (1c) and
repeat as step 4.
6. Repeat sharpening each side in turn
until a clean sharp edge is attained.
7. Switch Power Unit off. Before
removing the module, ensure that the
grinding wheel has stopped.
To Next Page
Loading...