Ploom S - Maintaining the Cleaning Brush

29
PS1_0001 [EN]
1 Open the Sliding Cover
and Cleaning Cover.
2 Perform cleaning.
Insert the Cleaning Brush into the
Tobacco Stick Holder and perform
cleaning.
3 Close the Cleaning Cover.
After cleaning is finished, pull out
the Cleaning Brush and close the
Cleaning Cover.
• The device retains heat for a short time
after use. Let the device cool o before
performing cleaning.
• Never attempt to remove fragments of
tobacco leaves by forcefully hitting or
shaking the device. Doing so may cause a
malfunction.
• Do not use the Cleaning Brush for any
purpose other than cleaning the interior
of the device.
• Only use the dedicated/recommended
Cleaning Brush.
• Never soak the Cleaning Brush in
detergent or other liquids to perform
cleaning.
• Only insert the Cleaning Brush into the
Tobacco Stick Holder. If you insert it into
the opening on the Cleaning Cover side,
this may damage the Cleaning Brush or
the device.
Maintaining the Cleaning Brush
Periodically rinse the Cleaning Brush with
water. Let it dry thoroughly before using
it again.