The ambient temperature around the test person should be stable, should keep
away from the larger �low fan, air-conditioning vents and so on.
When people moving from one place of lower temperature to another place of
higher temperature, should at least remain in the test environment more than 5
minutes, to be consistent with the ambient temperature after the re-measure-
ment.
Wait at least 1 second for the next measurement. If the continuous measurement
of �ive times, it is recommended to wait at least 30 seconds and then continue
measurement.
You cannot use the thermometer in place where the sun is strong.
If for some reason the low forehead temperature measurement can try to align
behind the ears. See �igure 3.
1.Turn on the thermometer by pressing the On/measure button. The thermometer
will perform self-test with all segments displayed for 2 seconds.
2.Align staff forehead to keep the distance, and then press the On/measure button
to start the measurement, read the data.
Note: 1) After full display over, you will hear a rattle or "beep beep beep" three times,
which means that the measurements have been completed, while the target value of
the measured temperature is displayed on the LCD, while backlit display according to
the appropriate setting among the three colors red, green, yellow one of. And the
General Setup and Use
Figure 3:Align behind the ears to measurement
Start measuring
Green means ready for next measurement. When 37.4℃-38.0℃, it's yellow ,means
slight fever warning. Please pay attention to body temperature. When the body
temperature is above 38.1℃, it's red , means high fever. Please take action to cool down
or go for a doctor.
2) To ensure the accuracy of the measurement, wait at least 30 seconds after 5
consecutive measurements.
30
To Next Page
Loading...