Mode conversion
Recalling and Erasing Memory Data
Parameter settings
Green means ready for next measurement. When 37.4℃-38.0℃, it's yellow ,means
slight fever warning. Please pay attention to body temperature. When the body
temperature is above 38.1℃, it's red , means high fever. Please take action to cool down
or go for a doctor.
2) To ensure the accuracy of the measurement, wait at least 30 seconds after 5
consecutive measurements.
When the device is running, pressing the MODE button to cycle conversion between
"body" mode and "surface" mode.
"body" mode is used for measuring human body temperature, the "surface " mode is
used to measure the surface temperature. (The factory default is "body" mode).
The last temperature taken before the thermometer powers off is stored in
memory, up to 50.
This product can be set according to the subjects of different colors and different
environments data to meet the different characteristics of populations or individuals.
Long press the SET button to modify the measurement parameters
1) In the boot or shutdown state, short press the MEMO button to view the
history of measured values.
2) An empty memory cell shows “---℃” or “---℉”.
3) Temperature readings can be stored in memory. Up to 50 temperature
readings can be stored into the memory cells and automatically overwrite
historical data.
4) In boot mode, press the MEMO button until the LCD display "CLR", which
means that all stored data is cleared completelyconds after the long beep, which
means that all stored data is cleared completely.
31
To Next Page
Loading...