Plusmed HTD8813 as below step:
1)Unit Set-F1
Under the boot mode .Long press SET button to enter F1, press the "MODE" or
“MEMO”button to switch Celsius and Fahrenheit temperature units, press the SET
button to con�irm the unit settings (factory default is Celsius).
2)Fever alert set-F2
Under F1 state, press SET button to enter the F2, press the “MODE” button to
decrease 0.1 ℃, press the "MEMO" button plus 0.1 ℃, long press to accelerate the
speed of temperature regulation, and �inally press the SET button to save. (The
factory default is 38.1 ℃)
3)Prompt sound settings-F3
Under F2 state , short press SET button to enter F3, press MODE button or MEMO
button to set voice switch, and press the SET button to con�irm the settings. (The
factory default is the voice Prompt to open).
Prompt sound settings ON/OFF function
Under the boot mode .Short press SET button to take on or take off the Prompt sound
function.
Restore to factory setting function
Under the boot mode, long press MODE button until LCD display “rst”. Two seconds
later ,former F1-F3 parameter back to factory setting.
32
To Next Page
Loading...