25
Press the TIME button for at least 3 seconds rstly , user icon will blink.
Then press TIME button again the display now indicates the set year,
during which the four characters blink.
The correct year can be entered by pressing the MEMORY button
Press the TIME button again. The display now switches to the current
date, during which the rst character (month) blinks.
The corresponding month can now be entered by pressing the MEMORY
button.
Press the TIME button again. The last two characters (day) are now
blinking
The corresponding day can now be entered by pressing the MEMORY
button.
Press the TIME button again. The display now switches to the current
time, during which the rst character (Hour) blinks
The corresponding hour can now be entered by pressing the MEMORY
button.
Press the TIME button again. The last two characters (Minutes) now blink.
The exact time can now be entered by pressing the MEMORY button.
Press TIME button (or TIME / DATE or TIME): the unit of measurement
will ash.
Press the “MEMORY to set the unit of measurement (mmHg or kPa )
Once you have made your settings, press the TIME button (or TIME /
DATE or TIME). The setting is conrmed and the clock starts running.
Now after all settings have been made, press the TIME button once again.
The date is briey displayed and then the time. The input is now con-
rmed and the clock begins to run.
Further Information
With each press of the button (TIME, MEMORY) one input is made (e.g. switch-
ing over from hours to minutes mode, or altering the value by +1). However, if
you keep the respective button depressed, you can switch more quickly to nd
the desired value respectively.
To Next Page
Loading...