PMC PMC6 - User Controls

USER CONTROLS
The following parameters can be congured using either the rotary encoders
on the rear panel of the speaker, or via the SoundAlign web interface.
• XBD Mode: On, Off
• Input Source: Analogue, AES3 L, AES3 R, AES3 L+R, Expansion Card
(if present)
• Level Trim: ± 10dB
• Max Analogue Input Level: +20, +24dBu
• Position: Free Space, Wall, Corner
• Desk Filter: On/Off
• Orientation (PMC 6 only): Auto, Portrait, Landscape
• Subwoofer HPF/LPF: On/Off, Freq (20-200Hz)
• Delay: 0.00 to 30.00ms
• Phase: Normal or Inverted
• LF & HF Shelves: On/Off, Gain (± 10dB), Freq (20 to 20kHz)
• Parametric EQ 1–5: On/Off, Gain (± 10dB), Freq (20 to 20kHz),
Q (0.05 – 10.00)
• Logo Brightness: Min (10%) to 100%
• Store Presets A, B, C
• Load Presets A, B, C
• Load Factory Default settings
• Clear XBD Links
XBD Mode
Options: ON or OFF
The XBD mode setting congures the monitor/subwoofer to perform as part
of an integrated XBD system. Usually this parameter is set automatically, so
it should only be modied by advanced users. See the XBD section for more
details.
Setting this parameter to ON applies a modied XBD crossover to both
speakers and changes the subwoofer’s low-pass lter to a high-pass lter
(for bass-management).