Pneumercator TMS2000 - Shift Inventory Log

Quick Start-up Guide TMS Series
TMS Quick Start-up Guide.docx
Page 17 of 24 November 21, 2017
Figure 10 - TMS2000 Sensor Wiring
Liquid Level Control Systems
PNEUMERCATOR
Bulletin 173 Rev. A (11/01/07)
Page 1 of 1
IDENTIFY THE TYPE OF SENSOR(S) TO BE INSTALLED. WIRING MUST BE TERMINATED ON THE
TERMINALS INDICATED BELOW TO ENSURE CORRECT OPERATION.
IMPORTANT! TMS2000 SENSOR WIRING INSTRUCTIONS
2-WIRE SENSORS
3-WIRE SENSORS
+V
S
RED
BLK
W
I
R
I
N
G
HS100-ND
M
O
D
E
L
RSU800
(NON-DISCRIMINATING)
RSU801
NOTE : CONDUCTOR COLOR PAIR PER
SWITCH POINT. REFER TO THE TAG
ATTACHED TO THE SENSO R.
LS600
LS600 LD / LS610
+V
S
GRN
BLK
ES825-200 SERIES
ES825-100 SERIES
M
O
D
E
L
HS100D
RSU800
(DISCRIMINATING)
RED
BLK
WHT OR GRN
RED
WHT OR GRN
BLK
*
GRN
RED
BLK
W
I
R
I
N
G
Questions? Contact Technical Support at (800) 209-7858
+V
S
+V
S
+V
S
+V
S
+V
S
* RED IS COMMON GROUND WIRE
NOTE: "S" = SIGNAL AND IS CONSECUTIVELY NUMBERED "S1"
THROUGH "S8" ON THE TMS2000 CIRCUIT BOARD
NOTE: "S" = SIGNAL AND IS CONSECUTIVELY NUMBERED "S1"
THROUGH "S8" ON THE TMS2000 CIRCUIT BOARD