12 - User manual
Set door closing modes
* Master code #
15
(for Zone 1)
25
(for Zone 2)
0 #
Pulse mode (default
setting). Each time a
code is entered or a
valid card has been read,
the door will open and
close automatically after
the set time interval
(between 0.05 sec. and
99 sec).
1 #
Toggle mode. Each time
a code is entered or a
valid card has been read,
the door will open but will
not close until the code is
entered again or the card
will be read.
Open the door with several cards
* Master code #
16
(for Zone 1)
26
(for Zone 2)
1 - 10 # Default setting 1
Note: The door will only open after all the cards have been read. For
example, by order * Master code # 16 3 #, you have to read 3 cards in
a row to open the door. This setting is only useful if you have set the
keypad to card access mode.
To Next Page
Loading...
