Datasheet 2
Englis h
CB Antenna PNI S60
Technical specifications
• Frequency: 26 - 28 MHz
• Power: 30 W (continuous) / 200 W (for short time)
• S.W.R.: ≤ 1.2:1
• Whip length: 590 mm
• Impedance: 50 Ohm
• Connector: DV
• Temperature: -26°C ~ +80°C
Installation
• Attach the antenna to a fixed bracket (eg. PNI L1) previously mounted on
your car using the connector on the cable included in the package.
• Insert the PL259 connector into the CB radio.
• Measure the SWR of the antenna in an open area using a reflectometer.
• To adjust the SWR, turn the screw on the end of the spike. For maximum
performance, we recommend that this procedure, called calibration, be
performed by qualified personnel. PNI antennas come tuned from the
factory.
To Next Page
Loading...
