Other Functions
RESET
RESET A: To reset learned channels to channels last set in Utility, hold TEST on power up.
LED blinks green twice to indicate reset. Release TEST. Advanced features set via
Utility are retained.
RESET B: To reset all advanced features and channels to FACTORY DEFAULTS, hold TEST on
power up for longer than 10 seconds. When LED blinks green 4 times, release.
B: Default Advanced Features
C.1 = ControlTL channel 1, Standard channel 1
C.2 = ControlTL channel 2, Standard channel 2
HyperSync Offset = -170 microseconds
High Speed Sync (FP Flash Sync) Disable Mode = not enabled
High Speed Sync (FP Flash Sync) Begins At = 1/400
Remote TTL Flash Sleep Mode = disabled
Basic Trigger Mode = disabled
Camera Model = Auto
Force TTL Master Mode = enabled
FlexTT5 Only:
Use ControlTL for Rx Channel = enabled
Flash Idle Time Out Mode = disabled
Transmitter Only Mode = disabled
Bottom Shoe Disable Mode = not enabled
All settings may be configured using the PocketWizard Utility available from www.PocketWizard.com
To Next Page
Loading...