“Wireless Manual” via E-TTL: MiniTT1 OO FlexTT5
Remote “Wireless Manual” flash using 580EX II
Canon’s “Setting the Flash Output for Each Slave” or “Wireless Manual” system allows setting
a remote flash to a desired manual level from the MASTER flash. You must use a 580EX II on
the MiniTT1 or FlexTT5 as transmitter. The original 580EX or earlier flashes cannot perform
this function via ControlTL radios. “Wireless Manual” uses controls similar to ratio mode.
Review your flash instructions for entering “Wireless Manual” mode. Follow the steps in the
ratio section for setting up your ControlTL radios to work with this mode.
Manual Flash
To Next Page
Loading...