Auto-Relay Mode
A FlexTT5 radio in camera’s shoe and connected with motor drive cord to P1 can receive
a radio trigger, trigger the camera’s motor drive, which in turn triggers a remote flash.
The channel used for relay transmit is 1 higher than taught channel, unless set via
PocketWizard Utility.
Example: If you taught FlexTT5 radio Standard channel 2, then relay transmit occurs on
Standard channel 3. Press TEST on hand-held trigger radio to begin relay sequence.
Status LED
Normal “waiting for trigger” operation = short blink every 2 seconds.
Normal short blink color indicates Battery Level:
Green Good battery
Amber Warning – battery low
Red Very low battery – change immediately
Steady red LED in sync with TEST indicates normal transmission.
(Hold for 10 seconds to teach – see LEARN mode)
Short red blink in sync with trigger indicates normal reception.
Rapid red blinking when not triggering or half-pressing camera indicates error condition.
Power off the unit, reseat all connections, and power back on.
Other Functions
English
9
To Next Page
Loading...