Point Mobile PM75 Quick Start Guide

Charging the Device
1. Assemble the AC/DC power supply, country plug and
USB type C cable.
2. Connect the cable to the USB connector of PM75.
3. Provide power by plugging the power supply to the wall
socket.
PM75 can be charged with charging cradle (sold separately).
LED Indicator
< Caution >
1. Always use an original power supply from Point Mobile.
Other chargers and cables may damage the PM75.
The device warranty does not cover any damage caused by
the usage of non-original power supplies.
2. Make sure the charger and cable is not wet.
1
2
No
Indicator
Status
Indication
1
Power
LED
Solid
green
Device
is fully charged
Solid
red
Charging
the device (with charger)
/
Battery is low (without charger)
Blinking
red
Charging temperature is too low or
high (with charger)
/
Battery is very low (without charger)
Alternately blinking
red
& green
Cannot
recognize the battery
2
Notification
LED
Solid
red
Device
entered hot swap mode
Blinking
blue
Notification
existing
Red
flash
Barcode
reading failed
Blue
flash
Barcode
reading success

Point Mobile PM75 Specifications

General

Brand	Point Mobile
Model	PM75
Category	PDA
Language	English