8
Place the freezer in a well ventilated place, far away from any heat
sources and direct sunlight. In order to avoid rust or reduce insulation
result, do not place it in a damp place.
Space above the freezer shall not be less than 30cm. The distance against
the two sides shall not be less than 10cm. Distance from the wall shall not
exceed 75mm, providing convenience to open and close the door and
disperse the heat.
Place the freezer on a flat and solid floor. (if it is not stable, you can level
the freezer with the regulating legs)
Placement
Attention
Make sure the mains power cable is not pressed by the freezer or other
articles.
Before connecting to the mains power supply, make sure the voltage
range of the freezer follows with that of the mains power supply.
Correct application of the freezer
Ensure that the freezer is placed correctly and stably. Be aware of all safety
matters that needing attention.
1. Connect the electricity
After connecting the electricity, it will enter into ex-factory state.
2. Put food into the freezer
Suggestion: after some time, the freezer will reach food storage temperature
or after the first stop of the compressor, put food into it, which is beneficial
to retain food freshness.
Note: if the set temperature is altered or new food is put in, the temperature
inside the box will balance after a time, which is determined by the
temperature alteration degree, temperature of ambient environment,
opening frequency, quantity of the food inside and so on.
To Next Page
Loading...
