Instr 9929139 Rev 01 2018-08 Page 8 of 13
10.REINSTALL SEAT.
a. Lift the driver side seat latch
A
located behind
seat bottom and firmly press down on seat
bottom to reinstall the driver seat
B
. Once
installed, pull forward on the seat back to
ensure the seat is fully latched and secured
into position.
11. REINSTALL WINCH COVER.
a. Reinstall lower front winch cover
A
with the
previously removed four push pin rivets
B
.
12.REINSTALL HOOD.
a. Place hood into position and rotate the two
hood latches to secure into position.
13.VERIFY WORK.
a. Confirm all electrical wires/connections have
been routed and connected per instructions.
b. Confirm that there are no exposed wires or
terminals.
c. Ensure all loose wires are secured away from
moving parts, sharp edges and heat sources.
14.VERIFY WINCH FUNCTION.
WARNING
BEFORE testing winch function, read the Operator’s
Manual that came with your winch. ALWAYS abide
by ALL safety warnings and operating procedures
outlined in the Operator’s Manual. Failure to comply
may result in serious injury or death.
a. With the vehicle key in the “ON” position, check
winch for proper operation using the installed
dash switch.
i. Shift winch from “FREE” to “LOCK” and
verify proper function.
To Next Page
Loading...
