Instr 9929140 Rev 01 2018-08 Page 10 of 17
16.VERIFY WINCH FUNCTION.
a. With the vehicle key in the “ON” position, check
winch for proper operation.
i. Shift winch into each of the three gear
settings, HIGH/LOW/NEUTRAL, and verify
proper function.
ii. Test function of Autostop feature. When
reeling in the winch rope, confirm that the
winch will turn off automatically when the
rubber puck reaches the aluminum fairlead.
The winch should not allow the rope to be
reeled in once the rubber puck has come
within a close proximity (typically 1” or less)
or made contact to the fairlead.
iii. If the Autostop is not functioning properly,
see troubleshooting information at the end
of the instructions.
To Next Page
Loading...
