Instr 9929140 Rev 01 2018-08 Page 6 of 17
9. CONNECT ALL ELECTRICAL COMPONENTS.
NOTE
Refer to the Electrical Connection Reference Guide
section at the back of the instruction manual for
images and detailed harness connection illustrations
of the proper electrical connections to aid in the
remaining electrical connections.
IMPORTANT
When making connections, ensure all wires are
routed and secured with cable ties away from all
heat sources, moving components and sharp edges.
Failure to do so may cause damage to electrical
wires and/or underlying components which may
cause the winch to malfunction.
a. Locate the dash switch connector (23B) and
connect it to the dash switch
w
as shown.
Once connected, reinstall dash switch panel by
aligning all mounting tabs with corresponding
slots and firmly press back into the original
position.
b. Next connect the winch contactor connector
(19B) and connect it to the control box
connector (23D).
c. Connect the Autostop fairlead connector (13A)
to the control box connector (19A).
d. Connect the wireless receiver harness
connector (5A) to the control box connector
(19C).
e. Locate the wireless receiver connector (5B)
and connect it to the dash switch connector
(23E).
To Next Page
Loading...
