1. Loosen the two 6 mm jam nuts
I
using the Belt Tension Adjuster tool
e
.
The adjuster tool is designed to allow access to the adjuster screw while
holding the jam nut.
NOTICE
Both adjuster screws will need to be turned outwards (counter-clockwise) to
decrease deflection. When making adjustments, only adjust one of the screws.
2. To increase belt deflection, use a 3 mm Allen wrench to turn one of the
adjuster screws
w
inwards (clockwise). To decrease belt deflection, turn the
set screw outwards (counter-clockwise).
3. Make adjustments until drive belt deflection is set to specification.
Drive Belt Deflection
1.13-1.25 in (2.85-3.2 cm)
90
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
