Name: Polaris 600 INDY 2013
Brand: Polaris
Rating: 4 (1 reviews)

To Next Page

To Previous Page

MAINTENANCE

Track Maintenance

Track Tension

5. Check for specified slack between the wear surface of the track clip

and the plastic slider. Refer to the Track Tension Data Chart on page

98.

If the track needs adjustment:

6. Loosen the rear idler shaft bolt.

7. Loosen the locknuts.

8. Tighten or loosen the track adjusting screws to provide equal adjust-

ment on both sides of the track.

9. Repeat the measurement on the other side of the track.

TIP:Check more frequently when the snowmobile is new.

10. Start the engine and slowly rotate the track at least five revolutions.

Let the track come to a stop (do not apply brakes).

11. Check track alignment (see page 100) and adjust as necessary.

12. Tighten the locknuts.

13. Tighten the idler shaft bolts.

14. Torque idler shaft bolts to 35 ft. lbs. (47.5 Nm).

Slack Measurement

Lock Nut

Adjusting Screw

Track

10 lbs. (4.54 kg)

Shaft

Bolt

16 inches

(40 cm)

Questions and Answers:

Need help?

Do you have a question about the Polaris 600 INDY 2013 and is the answer not in the manual?

Polaris 600 INDY 2013 Specifications

General