Polaris FST IQ Cruiser User Manual (English)

Questions and Answers:

J
Janet RobertsAug 18, 2025
What to do if my Polaris Snowmobiles engine turns over but fails to start?
- R
  Richard McknightAug 19, 2025
  If your Polaris Snowmobile engine turns over but fails to start, first, make sure you have fuel. If the fuel is old or not recommended, replace it with fresh, recommended fuel. Inspect the spark plugs; if they are fouled or defective, replace them. Also, check if the fuel filter is clogged and replace it if needed. Finally, ensure the battery voltage is at 12.8 VDC by recharging it if necessary.
C
cherylstrongAug 21, 2025
Why is the engine speed, RPM, or boost limited on my Polaris FST IQ Cruiser?
- A
  Aaron MartinAug 21, 2025
  If the engine speed, RPM, or boost is limited on your Polaris Snowmobile, it could be due to several reasons. A jammed track could be the problem; remove any foreign objects, check if the slider is melted to the track clips due to lack of lubrication, or if the track is iced up or frozen to the ground. Another cause might be a jammed clutch, so check for a twisted belt or broken spring.
A
Anthony SimmonsAug 23, 2025
What causes a Polaris Snowmobiles engine to run irregularly, stop, or lose power?
- K
  Kelly PotterAug 25, 2025
  If your Polaris Snowmobile engine runs irregularly, stops, or loses power, start by checking the fuel quality and replacing it with fresh, recommended fuel if it's poor or low octane. Inspect the spark plugs for fouling or defects, and clean or replace them as necessary. Also, ensure the fuel vent line isn't kinked or plugged, and inspect and clean or replace the air filter if it's clogged. Low battery voltage can also cause this issue, so recharge the battery to 12.8 VDC.
E
Emily McgrathAug 26, 2025
What causes harsh drive clutch engagement on a Polaris FST IQ Cruiser Snowmobiles?
- B
  Brandon WeaverAug 26, 2025
  If you experience harsh drive clutch engagement on your Polaris Snowmobile, replace the drive belt with the recommended belt if it is worn.
P
Patricia AriasAug 28, 2025
How to troubleshoot a Polaris FST IQ Cruiser Snowmobiles engine that doesn't turn over?
- P
  parkyvonneAug 28, 2025
  If your Polaris Snowmobile engine doesn't turn over, begin by recharging the battery to 12.8 VDC if the voltage is low. Check all battery and solenoid connections and tighten any loose connections. Ensure the engine stop switch is in the ON position.
J
jenniferwarnerAug 30, 2025
How to prevent drive belt wear/burn on Polaris Snowmobiles?
- J
  jennifer63Aug 30, 2025
  To prevent drive belt wear or burn on your Polaris Snowmobile: * Drive at higher RPM and check belt deflection. * Warm the engine for at least five minutes, especially in cold weather, and break the machine loose from the snow. * Avoid towing in deep snow and use fast, aggressive throttle to engage the clutch. * Avoid riding with high RPM and slow speed, and check for snow ingestion.
H
Heather NashSep 1, 2025
Why does my Polaris FST IQ Cruiser Snowmobiles engine backfire?
- M
  Mark MillsSep 1, 2025
  If your Polaris Snowmobile engine backfires, inspect, clean, and/or replace the spark plugs if the spark is weak. Ensure the spark plug gap and heat range are correct, setting the gap to specifications or replacing the plugs if needed. Replace old or non-recommended fuel with fresh, recommended fuel. Check all ignition connections and tighten any loose connections.
A
Aaron RobertsSep 4, 2025
What to do if a Polaris FST IQ Cruiser Snowmobiles engine is overheating?
- S
  stevendownsSep 4, 2025
  If your Polaris Snowmobile engine is overheating, stop and cool the engine. If snow conditions are inadequate, drive into snow frequently to prevent overheating. Check the coolant level and look for leaks, bleeding the system if the coolant level is extremely low. Also, clean any snow and debris from the radiator to ensure unrestricted airflow.
A
Andrew WilliamsSep 6, 2025
Why is the steering heavy on my Polaris FST IQ Cruiser?
- D
  Douglas MartinSep 6, 2025
  If the steering on your Polaris Snowmobile feels heavy, check the skags and skis for any damage. Ensure that the spindles and all steering components turn freely. Also, check the ski alignment.
B
brennanphillipSep 8, 2025
What causes a Polaris FST IQ Cruiser front end to push?
- R
  randyrodriguezSep 8, 2025
  If your Polaris Snowmobile's front end pushes, check for worn skags. Inspect for binding front suspension shafts and steering components, greasing all pivot points after elevating the front of the machine.

Polaris FST IQ Cruiser Specifications

General

Engine Displacement	750 cc
Track Width	15 in
Engine Cooling	Liquid
Fuel System	Electronic Fuel Injection
Starter	Electric
Ski Stance	42.5 in
Track Type	Cobra
Oil Capacity	3.5 qt
Track Length	136 in
Fuel Capacity	11.5 gal
Front Travel	10 in
Features	Digital gauge