115
MAINTENANCE
Lubrication
Driveshaft Bearing
Inject grease into the fitting on the speed-
ometer sensor housing until grease purges
from the seal on the inside of the tunnel.
This should take approximately two
pumps. Do not use more than four pumps.
Throttle Cable
Lubricate the throttle cable lightly
with grease or oil. With the
engine off, turn the handlebars to
the left and lubricate liberally as
shown.
Front Suspension
The front suspension and steering components do not require lubrica-
tion.
Fitting
To Next Page
Loading...
