90
MAINTENANCE
Hydraulic Brake Inspection
Frequently inspect the brake
lever reserve. Firmly depress
the brake lever and measure
the clearance between the lever
and handlebar grip (A). This
distance, called brake lever
reserve, should be no less than
1/2″ (1.3 cm).
Brake pads must be replaced
when the brake pad material
becomes t hinner than the backing plate (approximately 1/16″). A kit is
available for replacing brake pads. See your deal er.
A
Brake failure during operation can result in serious injury or death.
Properly functioning brakes are vital to your safety. Be sure the
brake pads do not drag on the disc and that brake lever travel is
not excessive.
Always replace brake pads when the brake pad material becomes
thinner than the backing plate (approximately 1/16″).
WARNING
To Next Page
Loading...
Need help?
General
